M18 Tool Holder — Heavy-Duty Wall Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Heavy-duty M18 tool holder for workshop walls. 6 perimeters, 20% infill. Supports through battery interface plane.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 46
- Wydruki
- 0
- Wyświetlenia
- 121
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Built like it means it. Heavy-duty wall mount for your heaviest M18 tools.
This isn't a quick friction-fit clip. It's a properly engineered wall mount designed for the heaviest M18 tools.
Why it exists: most M18 tool holders I came across were undersized, ugly and poorly thought through. No backplate, so the tool wears against the wall it hangs on, and the weight hangs on the battery terminals.
The backplate supports the tool through the battery interface plane — not the terminal interface, which was never designed to carry load. A bottom plate protects the tool body from the mounting surface.
Deliberate comfortable fit — not a tight friction fit. Tight fits cause tool rails to creep and deform over time.
Designed by MBKing - Mogensbæk Engineering, Denmark. Originally designed in 2020, tested in real work environments for 3+ years.
PRINT SETTINGS — FOLLOW THESE
This holder carries real weight. Deviating from these settings is at your own risk — a failed holder means a dropped tool.
Material: PETG strongly recommended (strength, durability, chemical resistance)
Perimeters/walls: 6
Top/bottom layers: 12
Infill: 20% (gyroid, grid, or crosshatch)
Supports: None needed
Layer height: 0.2mm
Orientation: Print standing up as oriented in the STL — this makes for the strongest rail
This is the heaviest print spec in the MBKing range. These settings are what makes this holder handle 5kg+ tools without flexing.
Print hot enough for a glossy/shiny surface finish. Matte = too cold = weak layer adhesion. Do NOT use HF-PETG (high-flow) — it has poor layer adhesion for structural parts.
You can print at lower perimeters or infill if you want to, but it's on you if the holder doesn't perform. I recommend 6P/12T+B and 20% infill for a reason.
HARDWARE
5x stainless steel A2 mounting screws (M4x35 or similar — not included in download).
MORE FROM MBKING
🔒 M18 Locking Tool Holder — The only Milwaukee M18 holder with a true mechanical lock. Pull-tab mechanism, spring-loaded retention, tested in work vans for 3+ years. Zero failures. → STL available on Etsy: mbkingmarket.etsy.com
🔋 M18 Battery Holder — Full-cover design with terminal protection. Fits all M18 batteries. → Free download here on [Printables/MakerWorld]
🔧 M12 Adjustable Holders — Clever toothed hinge mechanism that fits ALL M12 tools and batteries. Wall, ceiling, under-shelf mounting — you set the angle. → Available on Etsy: mbkingmarket.etsy.com
Full range of physical holders — Premium PETG with stainless steel hardware, shipped within EU. → mbkingmarket.etsy.com