1 / 4
Power XL 345 Filaments Loader for Prusa XL — zdjęcie 1
1 / 4

Power XL 345 Filaments Loader for Prusa XL

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

electric filament loader for Prusa XL powered by the printer (variable number of filaments 3 4 5 ) - works with flexible

Ocena
0 / 5
Polubienia
20
Pobrania
23
Wydruki
0
Wyświetlenia
1110
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Standard Digital File License

Prusa XL needs an filament loader. This model is powered by Prusa XL printer power source (24V), is easy to print (no supports, 0 infill), install and it works even with flexible!

Videos

Bill of materials

Printing

Open the 3 filaments as project the 3mf file with PrusaSlicer. No supports or infill needed.

If you want 4 or 5 filaments the files from the 4/5 filaments folder. The motor case the key files are the same.

Assembly and install

Install a 683ZZ bearing in the key. Use an M3x6 headless screw to secure it or a printed pin (included)

Optional: paint the ends:

Insert some PTFE tube (32 mm), trim it then insert a PC3-M6 connector

The first of the three keys is ready. 

Cut the bridges then install three switches:

Put an M3x12 screw:

Install the motor:

Cut a 65 mm rod (or print the 65mm plastic shaft) and put the 6mm-5mm coupling connector, then three extruder drive gears, then MR115-2RS Ball bearing.

Connect the motor to the body using 2 M3x12 screws:

Remove the plastic of the ends the wire (3 cm) then solder them.

Cut the wires, drive the throw the hole the the motor and crimp them using:

  • for the wires the connect to printer power source (32 cm): two ring terminals and 2.8 two female connectors 

  • for the switch wires (15 cm): one female 2.8 connector and and 2.8 male connector

Connect the ring wires to the Prusa XL power source:

Install the device on the side frame, after inserting T spring nut M3 for 3030 then screw in the M3 screw (after raising the gears shaft):

Connect the wires to the motor:

Install the keys and secure them with a M3x45 screw on the left. As a safety pin, the keys can be blocked using the Prusa M3 metal bar or an M3x45 screw

Early prototypes

This model is not meant to be used with the side filament sensor (I don't use it).  The following models work with the side filament sensors:

Tagi