1 / 1
Short 33rpm spindle for Dual 1218 turntable — zdjęcie 1

Short 33rpm spindle for Dual 1218 turntable

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Got a used Dual 1218 turntable off Craigslist for a relative, fixed it and now it's working but it was missing the…

Ocena
0 / 5
Polubienia
3
Pobrania
36
Wydruki
0
Wyświetlenia
203
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Audio
Licencja
Creative Commons — Attribution

Got a used Dual 1218 turntable off Craigslist for a relative, fixed it and now it's working but it was missing the center spindles. So I tossed design this together in about 15 minutes, and printed it in about 25 minutes. It's for single-play 33 rpm (never stack records!!), and works great. It will also fit Dual 1257, and probably other models (1228, 1219, 1229 I'm pretty sure, probably loads of others from the 70s and 80s. Quick print, I used Pillar supports (in Slic3r PE) but it might print without. Beats paying $15 for one from ebay!

Print Settings

Printer:

Folgertech FT-5

Rafts:

No

Supports:

Yes

Resolution:

0.25mm

Infill:

40%


Notes:

Make sure your peripheral number is small enough for the relatively thin walls of this. You can also print it 100% infill if you want, since that's pretty much what it comes out to, though that can make overextrusion a problem.

Category: Audio

Tagi