1 / 7
Sidekick64 Cartridge Case: 4 LED holes and closed jumper holes at upper side — zdjęcie 1
1 / 7

Sidekick64 Cartridge Case: 4 LED holes and closed jumper holes at upper side

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a remix of the upper side of Sidekick64 Cartridge Case by bigby. 4 LED holes and closed jumper holes.

Ocena
0 / 5
Polubienia
2
Pobrania
10
Wydruki
0
Wyświetlenia
61
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a remix of the upper side of the nice Sidekick64 Cartridge Case by bigby. 
I have added 2 more holes to see all 4 LEDs. Further I have closed the jumper holes at the front. Since I use my Sidekick64 only with a C64 I saw no need to change the jumper settings (powering through C64, usage of the Opt-button, delay). In my opinion this can be set up during assembly. If changing the settings becomes necessary the case must be opened, which is ok for me.

I have also put a model only with the 4 LED holes modification (but open jumper holes).

This is only the upper part of the case! The lower part can be found here: 

https://www.printables.com/de/model/122968-sidekick64-cartridge-case

Please note the license for this design! It does NOT allow for commercial use.

Use the same print settings as for the original model.

Tagi