1 / 6
Filament Guide -MK4s to MK3 - PTFE and Swivel — zdjęcie 1
1 / 6

Filament Guide -MK4s to MK3 - PTFE and Swivel

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A filament guide that accepts a 1/4" (6mm) OD PTFE tube and has a swivel guide.

Ocena
0 / 5
Polubienia
2
Pobrania
13
Wydruki
0
Wyświetlenia
108
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
GNU General Public License v3.0

Summary:

  • A filament guide that accepts a 1/4" OD PTFE guide tube and then transitions to a swivel guide. PTFE tubes may very in size but mine measured roughly .26" and fit perfect. 

Features:

  • No hardware needed. 

  • Swivel filament guide for more freedom of movement

  • The swivel arm snaps into the base arm.

  • Swivel is print in place

  • PTFE tube snugly held without any fittings

  • Base without the swivel arm is included in case you only want an arm that accepts a 1/4" (6mm) PTFE tube

  • Aids in the use of a dry box such as the PolyDryer and PolyDryer Box shown in the images. (Side note: In combination with my Spool Desiccant Holder I am able to achieve a humidity around 20% with PLA and around 10% for ABS, PETG, PCTG)

Examples prints:

  • Printed with 3DFuel's PCTG  PETGs better cousin. PLA will likely work just fine.

  • .4mm nozzle

  • .2mm layer thickness

  • 20% cubic infill

  • Set to Prusa's balanced template for 3D Fuels PCTG

  • 5mm brim just in case.

  • I also set "snug" supports only for the swivel arm end as there is a small area that is floating above the bed. The slicer screenshots show show my setup. 

Minor Flaw:

  • One small area on the rounded end of the main base came out a little "wavy". It is not real noticeable and I don't mind it but its not perfect. (left side) I think its due to the proximity to the heat bed and being an overhang. Adding another perimeter pass or messing with some overhang setting may improve this. I have not tried supports or anything to improve it. Let me know if you try something that works better.

Possible Remix:

  • Add a larger hole in the swivel to allow the PTFE tube to travel all the way to the extruder, if you have that sort of set up. I currently do not but may add this to my MK3 down the road. I have not felt the need for it yet as I have a CoreOne+ as well.

Products:

Disclaimer:

  • Links may take you to Amazon.com or Prusa.com for products I endorse and use on a regular basis.

  • JD3D is not responsible for any damage or harm caused by improper production, assembly and use.

Tagi