Filament Guide -MK4s to MK3 - PTFE and Swivel
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A filament guide that accepts a 1/4" (6mm) OD PTFE tube and has a swivel guide.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 13
- Makes
- 0
- Views
- 108
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- GNU General Public License v3.0

Summary:
A filament guide that accepts a 1/4" OD PTFE guide tube and then transitions to a swivel guide. PTFE tubes may very in size but mine measured roughly .26" and fit perfect.
Features:
No hardware needed.
Swivel filament guide for more freedom of movement
The swivel arm snaps into the base arm.
Swivel is print in place
PTFE tube snugly held without any fittings
Base without the swivel arm is included in case you only want an arm that accepts a 1/4" (6mm) PTFE tube
Aids in the use of a dry box such as the PolyDryer and PolyDryer Box shown in the images. (Side note: In combination with my Spool Desiccant Holder I am able to achieve a humidity around 20% with PLA and around 10% for ABS, PETG, PCTG)
Examples prints:
Printed with 3DFuel's PCTG PETGs better cousin. PLA will likely work just fine.
.4mm nozzle
.2mm layer thickness
20% cubic infill
Set to Prusa's balanced template for 3D Fuels PCTG
5mm brim just in case.
I also set "snug" supports only for the swivel arm end as there is a small area that is floating above the bed. The slicer screenshots show show my setup.
Minor Flaw:
One small area on the rounded end of the main base came out a little "wavy". It is not real noticeable and I don't mind it but its not perfect. (left side) I think its due to the proximity to the heat bed and being an overhang. Adding another perimeter pass or messing with some overhang setting may improve this. I have not tried supports or anything to improve it. Let me know if you try something that works better.
Possible Remix:
Add a larger hole in the swivel to allow the PTFE tube to travel all the way to the extruder, if you have that sort of set up. I currently do not but may add this to my MK3 down the road. I have not felt the need for it yet as I have a CoreOne+ as well.
Products:
Disclaimer:
Links may take you to Amazon.com or Prusa.com for products I endorse and use on a regular basis.
JD3D is not responsible for any damage or harm caused by improper production, assembly and use.