Shower Hose Connector Nipple — Villeroy & Boch / Gustavsberg Thermostatic Valve (M20x1.5 → G1/2") replacement
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
M20x1.5 → G1/2" shower hose nipple for Villeroy & Boch / Gustavsberg thermostat valve. Print PCTG.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 243
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Replacement for the OEM grey plastic connecting nipple that sits between a Villeroy & Boch (or Gustavsberg) thermostatic shower bar valve body and the shower hose.
The original part is a small grey plastic piece that can crack. The official brass replacement exists but is hard to find and costs ~8–60€ depending on where you source it. This print gets you back in the shower same day.
SPECS
Top: M20×1.5 external thread + O-ring groove (screws into valve body)
Bottom: G1/2" external thread (shower hose connects here)
Total height: ~19mm (matches OEM plastic part)
OEM part numbers:
GB41634757 01(Gustavsberg), 178787 (Oras), 92517800 (Villeroy & Boch)OEM EAN:
7393792210034
PRINT SETTINGS
Printed on: Centauri Carbon
Material: PCTG recommended — good heat/chemical resistance for hot water under pressure. PETG may work short-term. Do NOT use PLA.
Walls: 5+ perimeters
Infill: 100%
Reuse the original O-ring. If you need a replacement, use a standard NBR O-ring with OD ≤22mm and 1.5–2mm thickness (e.g. 20×2mm or 19×2mm — available at any hardware store).