JessEm Pow-R-Tek Router Air Intake
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A less $ alternative to Jessem's Air intake parts.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 67
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
An air intake system for the JessEm Pow-R-Tek router. A full setup requires 2 elbows, 1 intersection, 2 hose to pipe adapters, and a flange,
The 2 elbows slide into the intersection on opposite ports, and this then friction fits onto the router. The downward port of the intersection goes to the hose adapter. A second hose adapter fits into the flange, which mounts to the side of your router motor enclosure. The hose used for this is a 50mm hose from Ali Express. If you want to use a different hose, print some adapters that transition from the ID of your hose to an outside diameter of 49.5mm.
Print instructions
Nothing special - use the filament of your choice. I used PLA+
Installation and use
The parts are all friction fit. Slide the 2 elbows into the intersection. Slide the 2 hose adapters into the ends of the hose. One adapter then slides into the intersection and the other into the flange. The elbows/intersection end then friction fits onto the two air intakes on the motor. Due to vibration, this fit may loosen over time. It's a good idea to check on it periodically, such as when changing bits.
See photos for more.