JessEm Pow-R-Tek Router Air Intake
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A less $ alternative to Jessem's Air intake parts.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 4
- Makes
- 0
- Views
- 67
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution
An air intake system for the JessEm Pow-R-Tek router. A full setup requires 2 elbows, 1 intersection, 2 hose to pipe adapters, and a flange,
The 2 elbows slide into the intersection on opposite ports, and this then friction fits onto the router. The downward port of the intersection goes to the hose adapter. A second hose adapter fits into the flange, which mounts to the side of your router motor enclosure. The hose used for this is a 50mm hose from Ali Express. If you want to use a different hose, print some adapters that transition from the ID of your hose to an outside diameter of 49.5mm.
Print instructions
Nothing special - use the filament of your choice. I used PLA+
Installation and use
The parts are all friction fit. Slide the 2 elbows into the intersection. Slide the 2 hose adapters into the ends of the hose. One adapter then slides into the intersection and the other into the flange. The elbows/intersection end then friction fits onto the two air intakes on the motor. Due to vibration, this fit may loosen over time. It's a good idea to check on it periodically, such as when changing bits.
See photos for more.