Crossgun turbo fan Skadis holder T-clip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Keep your Crossgun off the desk. Clips onto IKEA SKÅDIS in seconds — no tools, no screws, no wobble
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 88
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
Crossgun Air Duster Holder for IKEA SKÅDIS — T-Clip Mount
Keep your air duster off the desk and always within reach. This holder mounts directly onto any IKEA SKÅDIS pegboard using the standard T-clip system — no screws, no tools, no drilling.
Why this exists
The Crossgun is a great little tool, but it always ends up rolling around the desk or buried under cables on a drawer. SKÅDIS boards are everywhere in maker setups, so the obvious solution was a dedicated holder that snaps right onto the board and keeps the duster exactly where you need it.
The mount system
The holder uses the IKEA SKÅDIS T-clip system. It clicks in, locks in place, and holds firmly. No wobble, no improvised solutions.
What makes this design different from other SKÅDIS holders: the back side includes two locking tabs that sit flush against the board. When you reach for the duster and pull it out, the holder stays put instead of rotating or popping off.
Small detail, big difference.
Print-friendly by design
This is one of those prints where everything just works:
No supports needed — the geometry is designed so nothing hangs in mid-air
PLA or PETG — both work perfectly; PETG gives a bit more flex if you want it
Single part — no assembly, no hardware, no inserts
Standard settings — 0.2mm layer height, 3-4 walls for solid clip strength
The clip tabs are designed with enough thickness to handle repeated on/off cycles without fatigue cracking, which is where thinner SKÅDIS mounts tend to fail over time.
Compatibility
Designed specifically for the Crossgun air duster. The cradle geometry matches the cylinder diameter of the Crossgun body exactly — it sits in snugly without being so tight that you fight it every time.
If you have a different cylindrical tool of a similar size, it may well fit too — check the dimensions in the files before printing.
No supports. No hardware. Just clip it on. Share your make if you print one — especially if you remix it for a different tool.