1 / 6
HOTO Measuring tape Skadis Holder (T-clip) — zdjęcie 1
1 / 6

HOTO Measuring tape Skadis Holder (T-clip)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A clean, minimal home for your Hoto tape measure. One print, one click, done.

Ocena
5 / 5
Polubienia
4
Pobrania
16
Wydruki
2
Wyświetlenia
68
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Creative Commons — Attribution — Noncommercial

Hoto Tape Measure Holder for IKEA SKÅDIS — T-Clip Mount

A clean, minimal home for your Hoto tape measure. One print, one click, done.

The problem it solves

The Hoto tape measure is one of those tools that looks too good to throw in a drawer — but without a dedicated spot, it always ends up somewhere it shouldn't be. This holder gives it a permanent place on your SKÅDIS board, exactly where you need it.

T-clip mount

The T-clip locks into the board securely and stays put. The back of the holder includes two anti-rotation tabs that press against the board surface, so when you grab the tape measure one-handed, the holder doesn't spin or pull away with it.

Designed around the Hoto

This isn't a generic cylindrical cradle. The geometry is modeled to match the Hoto tape measure's profile exactly — the curved body sits flush and snug, with enough retention to hold it confidently but easy enough to grab without a second thought. It just looks right on the board too, which with a tool this well-designed matters.

You have 2 designs: one normal and saquare and the other with an angled side to give it some flair. The round version will come, but right now the quality is not that good on the overhang area.

Single part. Zero supports.

The whole thing prints as one single piece — no assembly, no hardware, no post-processing. The geometry is oriented so that every surface prints clean without a single support structure. What comes off the bed is ready to mount.

  • PLA or PETG — both work great

  • 0.2mm layer height, standard settings

  • 3–4 perimeters recommended for solid clip strength

  • Print orientation: flat side down, exactly as designed

Minimal by intention

No logo embossing, no decorative ribs, no unnecessary bulk.

One piece. No supports. Clips straight onto SKÅDIS. Share your make — especially if you print it in a color that matches your setup.

Tagi