Brake Line Bracket for Motorcycle Front Fender
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a bracket to mount the brake line with the rubber sleeve part on the front fender of a motorcycle.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 65
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This fits the wider rubber part of the brake line that is 14 mm in diameter.
I tested this with HEL brake lines on a GSX-R600 K8.
It requires:
A 4x1.5 mm zip tie (or smaller)
Two rivets: it's designed for a 3 mm rivet, but it might require a 2 mm rivet depending on your printer.
Printing:
I used ASA because of its heat-resistance and UV-resistance properties. Make sure to disable or reduce fan do improve layer adhesion with ASA.
Consider printing 90 degrees on its side for improved rigidity. If your layer adhesion is not the best, printing on its side helps a lot.
No supports needed
CAD source available via [OnShape](https://cad.onshape.com/documents/edcd1bf28c3ccf5a79d5fab8/w/e9b8a159a41bb3fae3af37ae/e/481df5bdc552757ca224456b?renderMode=0&uiState=69c80c378cd5422fc031ece9)