MATX 2U DeskPi Rackmate T2 Tray
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A tray to hold a MATX motherboard in a DeskPi Rackmate T2 10 inch rack
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 56
- Wydruki
- 0
- Wyświetlenia
- 350
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
WILL PROBABLY NOT WORK ON OTHER RACKS OTHER THAN THE RACKMATE T2 UNLESS YOUR SPACING BETWEEN BACK AND FRONT IS 10 1/4 INCHES OR 260.35MM
PCIE CARDS WILL NOT FIT WITH BRACKET INSTALLED
V1: Release
V2: Changed back cutout to not block motherboard IO
A tray to hold a MATX motherboard in a DeskPi Rackmate T2 10 inch rack.
Fits snug into the rack, you need quite a lot of room to put it in on an angle so I would put this in first before anything else. There is just enough clearance on the side walls to put the power supply under and feed the cables up. I had to modify my motherboard and remove the VGA port using a hot air rework station because it protruded to far out in the corner. On the front there is a 16mm hole for a power button.