Begode Blitz Pro 168 volt EUC Screen Guard
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple screen guard for the screen that's still in the stock position on the Blitz Pro 168V.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 74
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
If you still have your Blitz Pro screen in the upper handle position, but feel like it needs a little protection in case of falls, this is a simple screen guard for you. It uses all stock hardware to install over the screen, and is secured in tightly so that it wont come off during a crash.
Print Settings
-TPU
-3 walls
-Gyroid infill at 20%
-Supports optional (depending on your printer calibration. IO personally used supports only on the screw holes to give it a cleaner edge for install.
INSTALLATION
Remove the 4 screws holding in the screen
Slide the Screen Guard over the handle arms, make sure the screw mounting holes go into the screw holes for the screen
Re-install the 4 screws back into the screen. It's a tight fit, so make sure to push those screws in while turning. Make sure they are seated well and the screen is secure.