Begode Blitz Pro 168 volt EUC Screen Guard
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple screen guard for the screen that's still in the stock position on the Blitz Pro 168V.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 14
- Makes
- 0
- Views
- 74
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Noncommercial
If you still have your Blitz Pro screen in the upper handle position, but feel like it needs a little protection in case of falls, this is a simple screen guard for you. It uses all stock hardware to install over the screen, and is secured in tightly so that it wont come off during a crash.
Print Settings
-TPU
-3 walls
-Gyroid infill at 20%
-Supports optional (depending on your printer calibration. IO personally used supports only on the screw holes to give it a cleaner edge for install.
INSTALLATION
Remove the 4 screws holding in the screen
Slide the Screen Guard over the handle arms, make sure the screw mounting holes go into the screw holes for the screen
Re-install the 4 screws back into the screen. It's a tight fit, so make sure to push those screws in while turning. Make sure they are seated well and the screen is secure.