Garage ESP Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Thank you walter for this awesome, handy model! Added the screw sockets, holes and engraving in Tinkercad:…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 28
- Wydruki
- 0
- Wyświetlenia
- 474
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
Thank you walter for this awesome, handy model!
Added the screw sockets, holes and engraving in Tinkercad: https://www.tinkercad.com/things/imjQSvoq28o-garage-esp-case
Printed in PET (235 degrees, 70 degrees bed, still warping unfortunately), fixed to the garage door opener using double sided tape (for now).
Another thing to remember for the next case: 0.5mm of tolerance may be ok for part that get tightly pressed together, but it lead to the perfboard fitting very tightly (I don't even know how I'm going to get it out again). Upside: In the end, I didn't need any screws.
Created with Customizer https://www.thingiverse.com/apps/customizer/run?thing_id=384919, using the following options:
interiorWidth = 52
interiorLength = 40.5
interiorHeight = 17
interiorFillet = 2.0
hingeWidth = 10
coverThickness = 1.5
sidewallWidth = 1.5
lidInsetHeight = 4
hingeThickness = 0.3
hingeLengthScale = 1.4
rimInset = 0.6
tabSize = 1
hingeFillet = 3
lidInsetOffset = 0.0
Category: Electronics