Garage ESP Case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Thank you walter for this awesome, handy model! Added the screw sockets, holes and engraving in Tinkercad:…
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 28
- Makes
- 0
- Views
- 474
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Share Alike
Thank you walter for this awesome, handy model!
Added the screw sockets, holes and engraving in Tinkercad: https://www.tinkercad.com/things/imjQSvoq28o-garage-esp-case
Printed in PET (235 degrees, 70 degrees bed, still warping unfortunately), fixed to the garage door opener using double sided tape (for now).
Another thing to remember for the next case: 0.5mm of tolerance may be ok for part that get tightly pressed together, but it lead to the perfboard fitting very tightly (I don't even know how I'm going to get it out again). Upside: In the end, I didn't need any screws.
Created with Customizer https://www.thingiverse.com/apps/customizer/run?thing_id=384919, using the following options:
interiorWidth = 52
interiorLength = 40.5
interiorHeight = 17
interiorFillet = 2.0
hingeWidth = 10
coverThickness = 1.5
sidewallWidth = 1.5
lidInsetHeight = 4
hingeThickness = 0.3
hingeLengthScale = 1.4
rimInset = 0.6
tabSize = 1
hingeFillet = 3
lidInsetOffset = 0.0
Category: Electronics