3D Printed Traditional Longbow Strap-On Quiver

This is my modern take on a traditional bowyer and hunting item. The 3D Printed strap-on longbow quiver. Another pain point addressed by this model is the wearing out of quiver foam, by printing only side walls and not top an bottom, TPU infill can be used as quiver "foam" that does not wear out and self heals. This model is sliced and build to be printed on a 225x225 print bed so that anyone with any commonly sized printer can make it for themselves.

Print files are in the recommended orientation and the rigid parts my example was printed in both PLA+/PLASS and in PETG. TPU is 95A high speed but any 95A TPU should do the trick.

When printing the quiver foam, set top and bottom shell to 0 and side walls/shell to .5mm, and 20% triangle infill, to achieve the same result as I did. 

Assembly requires:

-4x 4x25mm flathead tapered m4 bolts and nuts.

-2x 4x20mm flathead tapered m4 bolts and nuts

-8x m4 washers ( extra to sandwich the straps to prevent tear out.

-2x straps, I made mine but i linked an alternative below along with what I used to make mine

-2x 4mm grommet, this helps to prevent tear out in the straps.

For the hardware and making options these are the amazon links to what I used.

-Make your own straps-

D-Ring: https://amzn.to/4m1cPZA

1” Strap: https://amzn.to/4bQXYMC

-Untested purchasable alternative-

Hook and loop strap: https://amzn.to/3NACADn

-Hardware-

4mm nuts: https://amzn.to/4tgrzpY

4mm washers: https://amzn.to/4cdd5Bh

4mm flathead: https://amzn.to/4dRFJcp

4mm grommet (kit): https://amzn.to/4bOV1fr

disclamer these are amazon affiliate links, if you are purchasing the items to make this it would be much appreciated if you used these links to support me.