Hand Crank Fan
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A portable fan powered by a hand crank and TPU pully belt drive.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 53
- Wydruki
- 1
- Wyświetlenia
- 392
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Share Alike
A portable fan powered by a hand crank and TPU pully belt drive.
DRIVE BELT MUST BE PRINTED WITH TPU
.2mm layer height
outer brim on all parts for adhesion
slim tree supports for both pullys
To assemble place both large and small pully on their slots on respective sides then attach the two plates by the two pegs in the middle. After plates are attached put the TPU drive belt around the pully system. The Crank comes in two parts, attach the crank shaft to the handle on the bearing side. The fan attaches to the hole on the end of the small pully, just push it down into the hole until it is in place.