1 / 4
Minimalist Heat Insert Press MGN9H 300mm remix — zdjęcie 1
1 / 4

Minimalist Heat Insert Press MGN9H 300mm remix

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Minimalist Heat Insert Press remix for MGN9H rail

Ocena
0 / 5
Polubienia
0
Pobrania
6
Wydruki
0
Wyświetlenia
95
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Gadgets
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Remix of SNASA's Minimalist Heat Insert Press — MGN9H 300mm Rail Version

This is a remix of SNASA's Minimalist Heat Insert Press adapted to use a MGN9H linear rail instead of the original LML12B. I redesigned the arm block and carriage mount to fit the MGN9H. It's not a perfect 1:1 replacement geometry-wise, but it's close enough and works well in practice.

I used a 300mm rail instead of the original 200mm — gives a bit more travel, which is nice.

Just print the two parts from this remix, then print everything else from the original and follow SNASA's assembly instructions — just swap the rail.

Changed hardware:

  • 1× MGN9H linear rail, 300mm (instead of LML12B)

Print settings:

  • 3 walls

  • 25% gyroid infill

  • Anything in that ballpark should work fine

Tagi