1 / 4
Modular Conduit to Cable Gland Enclosure 62mm x 100mm — zdjęcie 1
1 / 4

Modular Conduit to Cable Gland Enclosure 62mm x 100mm

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Compact modular junction box / conduit transition box with interchangeable side inserts and screw-on lid.

Ocena
0 / 5
Polubienia
14
Pobrania
25
Wydruki
0
Wyświetlenia
228
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution

I designed this small modular box to make neat cable transitions from conduit to cable glands. It features 3x M20 knockouts, and 1x M25 knockout. Behind the knockouts is a hex shape designed to capture the cable gland nuts so you can tighten them up by hand from the outside.

It is designed to be replaceable without needing to reroute the wires, which is why the cable glands mount from the edge. The idea is you can use it outside, and replace it if it doesn't last. I've included STEP files if you want to modify the design.

Printing suggestions

  • Print the box body with the back/bottom flat on the build plate

  • Print the lid with the top/front flat on the built plate

  • Print the inserts flat

  • Use >3 perimeters

  • Use 30–40% infill for good strength

  • PETG or ASA is a better choice than PLA if it will live somewhere warm, damp, or outdoors

Assembly

  • Use 4x M4 bolts and 4x M4 heatset inserts to mount the lid

  • Fit the blanks into the side openings

  • Fit cable glands and conduit adapters, but don't fully tighten them

  • Route cables / conduit as needed

  • Fix the lid in place with bolts

  • Tighten up the conduit adapters and cable glands.

Important safety note / disclaimer

This is a 3D printed enclosure, so suitability depends on your application, material choice, environment, and local regulations. I’d recommend this for low-voltage / cable management / strain-relief type uses.

Tagi