Buckyball cubizer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This print is for making a cube out of buckyball or neocube magnets easier
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 41
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution
Have a mixed set of buckyballs and neocube 5mm magnets and was having a hard time getting them back in a cube to put back in the packages. This print makes it a bit easier and should work with any 5mm spherical magnets.
To use load one row at a time and ram down with the ejector print. Do this until the first layer is fully populated. Then move up a row and do it again. Once the print is full you can use the ejector to slowly push the balls out into the final cube form. Note there is quite a bit of resistance when you start pressing a 7x7x7 cube out but it does work.
Recommend printing in a transparent material so you can see which rows are filled as you go.