Buckyball cubizer
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This print is for making a cube out of buckyball or neocube magnets easier
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 3
- Makes
- 0
- Views
- 41
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Toys & Games
- License
- Creative Commons — Attribution
Have a mixed set of buckyballs and neocube 5mm magnets and was having a hard time getting them back in a cube to put back in the packages. This print makes it a bit easier and should work with any 5mm spherical magnets.
To use load one row at a time and ram down with the ejector print. Do this until the first layer is fully populated. Then move up a row and do it again. Once the print is full you can use the ejector to slowly push the balls out into the final cube form. Note there is quite a bit of resistance when you start pressing a 7x7x7 cube out but it does work.
Recommend printing in a transparent material so you can see which rows are filled as you go.