AWS DeepRacer Evo Shell | Lightweight & Durable (1mm PETG)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a custom-designed replacement shell for the AWS DeepRacer Evo.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 30
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
Description
This is a custom-designed replacement shell for the AWS DeepRacer Evo, specifically engineered for weight efficiency and durability during high-speed autonomous racing. At only 1mm thick, this shell significantly reduces the car's center of gravity and overall mass compared to the stock housing, allowing for snappier cornering and improved battery life.
Designed with a streamlined profile, the dimensions are optimized at 320mm (L) x 80mm (W) x 100mm (H) to provide a snug fit over the chassis while maintaining enough clearance for the dual camera setup and LIDAR sensor.
Print Settings & Recommendations
To achieve the best results with this thin-wall design, I recommend the following:
Material: PETG (Highly recommended for its impact resistance and flexibility compared to PLA).
Wall Thickness: 1mm (Set your wall loops/perimeters to achieve a solid 1mm skin).
Infill: 5% (The 1mm walls should be printed solid for structural integrity).
Supports: Minimal supports may be required for the wheel arches and sensor cutouts depending on your printer’s bridging capabilities.
Layer Height: 0.2mm for a good balance of speed and surface finish.