1 / 8
5-6GHz 16dBi Horn Antenna — zdjęcie 1
1 / 8

5-6GHz 16dBi Horn Antenna

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

16dBi horn antenna designed to be 3D printed and covered in copper tape

Ocena
0 / 5
Polubienia
2
Pobrania
45
Wydruki
0
Wyświetlenia
166
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution

5-6GHz 16dBi horn antenna. Just need to trim the driving wire to the desired range using a VNA (like the LiteVNA/NanoVNA). Apply tape VERY WELL and across the areas where the screws are (see photos for examples). The smoother the tape and better the connection between the components the better. Make sure to solder the SMA connector to the copper. I would also recommend using super glue to keep the SMA connector in.

Designed for 3M screws.

For more information the design, check out my blog post: https://quizque.ca/posts/5ghz-3d-printed-antenna/

Tagi