BetaFPV VR04 front plate

This model is 1st phase of my technical improvization to make low latency, vrx diversity goggles. Next steps further will be mounting external vrx while maintaining default functionality if posible. For now i progress by mesauring and verifying that pcb PWR would handle to power all thinks right and cool. Meanwhile caps or other suggested upgrades in comments could be discussed.

! - Disclaimer: Attempting such invasive task could cause permanent damage to whole unit. Consider your skill level in advance and accept your full responsibility of your actions.

Hot tip: use magnetic screw driver to catch screws, they could fall inside and short things on a pcb while internal battery is connected.

This is clear/plain version without any graphics. It is up to you to add them in slicer by text tool or .svg for pure  personalification. Printed from bambulab studio, Prusa mk3 profile on Sovol SV06 printer.

File printed flat on bed.

bend in place by "multifinger gymnastics" - most hard part to not brake anything

...and stabilized only print by hot air to hold shape and relief strain. (if you can set temperature, use temp ° close to your printbed from material profile).

While in it, I changed stock antenna ufl to rp-sma 90° cable to straight ufl to sma. Lenght around 100mm will work.

For hardware assembly reference see video of BetaFPV VR04 internal antena mod by: Leshy FPV