OpenGrid Command Strip Mounts (1x, 2x, 4x) "Easy Open"
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Cobbled together a few niceties from the available models + tightened up the lock a bit.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 74
- Wydruki
- 0
- Wyświetlenia
- 272
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
None of the current models in this space quite met what I was looking for. I printed one and the model didn't actually fit, there wasn't a STEP source so I just decided to make some either to serve as a base or to use. I have printed and tested all sizes of this model and used them to mount my opengrid wall.
Printing
This uses the tool from Leo's model (you'll need to print that) here. Print per the model orientation (Wall/command strip side down). The models will warn about cantilevers, its fine. This is how the breakaway works. I did my best to make the breakaway as printable as possible.
I tested slicing this in Orca slicer with 2-4 walls 0.4 nozzle and they all seemed to slice correctly. The key thing to watch for is that the bridges have something to anchor to on the layer below at the edges. I did my best to model this in a forgiving way but its possible some combination of slicer settings could break this. I printed mine with 4 walls. The contact areas are designed to be minimal, nozzles larger than 0.4 are not recommended and may not slice correctly - I have not tested.
Take the tool, turn clockwise to break the adhesion. Profit.