Vertical Cupholder / Mugholder | Screw-Mounted
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is the vertical mounted remix of my desk mounted mugholder. It's a little bit more refined. The handle cutout is…
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 43
- Wydruki
- 0
- Wyświetlenia
- 201
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is the vertical mounted remix of my desk mounted mugholder. It's a little bit more refined. The handle cutout is just a little bit lower and the diameter is just a little increased. This does also fit special mugs a lot betther, while keeping the same functionality for most mugs.
Please consider not to use PLA, when putting hot mugs into it, since PLA might deform at those temps. You'd better go for PETG or else.
16% Gyroid Infill has been used and 0.8+0.45mm Wall thickness.
Category: Office