(Yet another) Sunvisor Glasses Holder, but designed for ABS/ASA printing
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A sunvisor glasses holder that was designed from the ground up for high warp materials
- Ocena
- 0 / 5
- Polubienia
- 35
- Pobrania
- 197
- Wydruki
- 0
- Wyświetlenia
- 525
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
It is just a sunvisor clip for a pair (or two) of sunglasses. The thing about it is that it was designed to be printed in high warp materials, such as pure ABS/ASA/PA/PC, using a thermal expansion grid on the bottom for controlled material contraction and a chamfer in order to all but eliminate the elephant's foot.
It should print as-is on basically any printer, without brims, rafts or draft shields. I designed, tested and printed mine on a Lack enclosed Sovol SV06 and in the 15 minutes it took to print it in ASA, the chamber barely got up to 30C. As for layer adhesion, I can't break it with bare hands, so I guess it's good enough?!
It will obviously print in PLA, PETG or any other material, but a car's interior temperature in the summer WILL deform lower temp materials. Also, I wouldn't trust HT-PLA for this job.