Moldex Respirator Box (Dishwashable, Water-, Dustproof & Strong)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Do you like this design and want to give a Tip for it? Do it here This Box is meant as a Transportbox for N95 / FFP2…
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 221
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Do you like this design and want to give a Tip for it? Do it here
This Box is meant as a Transportbox for N95 / FFP2 or FFP3 Respirators. It was optimized for Valveless Moldex 2400 NR D Masks, since those seem to be the best affordable ones around europe yet.
2 Valveless Masks can be stacked without pressure.
It is meant to make a transport in your Backpack or out of the Backipack possible. If a very Smooth TPU-Material is used for the Seal (Like Firberlogy 30D), it was waterproof in my case.
Both the parts can be printed in 3,5 Hours each, if correct slice-settings are used, even though they are quite massive. Please refer the description for that.
This Box was clearly inspired by the Frog Box v2.0, but completly designed from scratch. Only the hinges and latches are taken 1:1
Print Settings
Printer:
Two Trees Saphire Plus (feat. E3D Hemera)
Rafts:
Doesn't Matter
Supports:
No
Infill:
25% Gyroid
Filament: Fiberlogy Easy-PETG Burgundy
Notes:
Its a Very fast and nice Print, if following Settings are used:
-Layer Height: 0.2mm-Linewidth: 0.8mm
-Outer Wall Line Width: 0.75mm
-Inner Wall Line Width: 0.75mm
-Infill Line Width: 0.45mm
-Wall Line Count: 4
-Top Surface Skin Layers: 1
-Top/Bottom Thickness: 0.8mm = 4 Layers
-Infill: 25% Gyroid
Category: Other