Two Trees Sapphire Pro / Plus Hemera mount for EBM Pabst RLF35
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This mount should is just the same, as the Sapphire Pro/Plus Mount from mordant80, but I remixed the fan duct to work…
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 36
- Wydruki
- 0
- Wyświetlenia
- 835
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This mount should is just the same, as the Sapphire Pro/Plus Mount from mordant80, but I remixed the fan duct to work with a EBM-Pabst RLF35, since they are used qute cheap around here.
Still experimenting with the flow-rate. 95% seems to be best.
This Mount worked best on my dual Z-Endstopps Sapphire Plus. By this revision, your going to reduce your Z-Height (350mm to 327mm) and your X-Axis (300mm/310mm to 292mm) a little bit.
The RLF is quite strong. I recommend to run it with up to 50% RPM only, since the heater cant keep up :-).
Used Firmware and Manual for connecting the BL-Touch:
https://github.com/RolfZuckowskiUltras/TwoTrees_Sapphire_RawMarlin
Print Settings
Printer:
TwoTrees Sapphire Plus
Rafts:
No
Supports:
No
Resolution:
0,16
Infill:
3D Gyroid 50%
Filament:
Prusa Prusament PETG
Urban Grey
Category: 3D Printer Parts