PlayStation SCPH-550X Parallel I/O Port Cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is replacement cover for Parallel I/O (or parallel port) of Sony PlayStation 1. I tried this on model SCPH-550X,…
- Ocena
- 5 / 5
- Polubienia
- 45
- Pobrania
- 633
- Wydruki
- 3
- Wyświetlenia
- 2407
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution
This is replacement cover for Parallel I/O (or parallel port) of Sony PlayStation 1. I tried this on model SCPH-550X, but most likely it will be compatible with any model with parallel port (from SCPH-100X to SCPH-750X). Latch is fully working, it will properly click in place.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.1
Infill:
25%
Filament: FDPlast PLA Grey
Notes:
You must print it as shown (second picture) , if you put it flat on the printing bed - latch won't have any springiness and will almost immediately break along layers. I recommend to print it with standard supports, but set "Support X/Y Distance" to 0.4 mm in Cura, otherwise it won't add all necessary supports (check preview before printing). Brim (3-5 lines) is also recommended. You can print it in 0.2 resolution, too, I've only used 0.1 for cleaner surface.
Category: Video Games