NextBase Duo Dashcam GPS module shell replacement

This model is a replacement shell for the GPS module in a NextBase Duo dashcam, to replace it if it breaks cause they're pretty weak where they attach to the suction base.

Print both sides in a heat and UV resistant filament, I used ASA.

Support will be required, I suggest printing with the outside of the shell upwards, this will require more support but give a nicer finish

Put the GPS module inside, it should fit snugly into the recess in the top shell, then route the cable out through the hole in the mounting and close the case with 4 M1.7x6mm plastic screws.