1 / 5
Low Profile Grip + Tripod Plate for Nikon 1 J5 [UPDATED 4 15 26] — zdjęcie 1
1 / 5

Low Profile Grip + Tripod Plate for Nikon 1 J5 [UPDATED 4 15 26]

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Combination grip and compact arca type tripod plate for Nikon 1 j5, now with no vertical option, but more pocketable.

Ocena
0 / 5
Polubienia
1
Pobrania
23
Wydruki
0
Wyświetlenia
113
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Photo & Video
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Update 4/15/2026

This update makes it clip onto the body's strap lug tighter, to reduce flex.

About the design

A lower profile, more-pocketable version of my grip and tripod plate for the Nikon 1 J5. Designed to keep your hand close to the position it would be in while using the camera without a grip, but with structure added to brace against. 

Known issues / things to be aware of

Bottom arca plate interferes with adapter FT-1's tripod foot

Because I wanted to hide the bottom tripod plate by pushing it all the way forward under the lens, it sticks out too far to use with adapter FT-1.
You probably shouldn't mount the camera by a thin plastic tripod plate on the body while heavy lenses and adapters are attached anyway, so I'm including an alternate version with no tripod wedge. I would simply put a generic plate on the FT-1 adapter's foot instead.
Stay tuned - I might design a dedicated plate for that at some point ;3c

No upper right strap connection point

This design pressure fits onto the body's factory upper right strap connector to reduce flex, and after doing that + beveling that upper edge to make it easier to reach your finger over to the shutter button, I wasn't happy with any of the places I tried putting an upper right strap connector.
Personally, I don't really use those anymore, just bottom right for a wrist strap - but if you want upper right, you could probably modify the design to add it. 

Attaching it

I used these screws: https://www.mcmaster.com/91792A533/
They are standard 1/4" 20 thread with a 1/4" shaft, and a 0.144" deep by 0.492" wide head. 

The grip presses tightly onto the body's built-in strap lug. To attach it, I press down into the table with the grip side down (see last image upload)

⚠ Disclaimer! Use at your own risk!

I have been using 3d printed tripod plate + strap connector combos for years with no problems, but ultimately the safety of your gear is up to you, and I take no responsibility for any damages caused if your copy of this design breaks or does not work with your gear.

Tagi