1 / 5
Low Profile Grip + Tripod Plate for Nikon 1 J5 [UPDATED 4 15 26] — image 1
1 / 5

Low Profile Grip + Tripod Plate for Nikon 1 J5 [UPDATED 4 15 26]

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Combination grip and compact arca type tripod plate for Nikon 1 j5, now with no vertical option, but more pocketable.

Rating
0 / 5
Likes
1
Downloads
23
Makes
0
Views
113
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

Update 4/15/2026

This update makes it clip onto the body's strap lug tighter, to reduce flex.

About the design

A lower profile, more-pocketable version of my grip and tripod plate for the Nikon 1 J5. Designed to keep your hand close to the position it would be in while using the camera without a grip, but with structure added to brace against. 

Known issues / things to be aware of

Bottom arca plate interferes with adapter FT-1's tripod foot

Because I wanted to hide the bottom tripod plate by pushing it all the way forward under the lens, it sticks out too far to use with adapter FT-1.
You probably shouldn't mount the camera by a thin plastic tripod plate on the body while heavy lenses and adapters are attached anyway, so I'm including an alternate version with no tripod wedge. I would simply put a generic plate on the FT-1 adapter's foot instead.
Stay tuned - I might design a dedicated plate for that at some point ;3c

No upper right strap connection point

This design pressure fits onto the body's factory upper right strap connector to reduce flex, and after doing that + beveling that upper edge to make it easier to reach your finger over to the shutter button, I wasn't happy with any of the places I tried putting an upper right strap connector.
Personally, I don't really use those anymore, just bottom right for a wrist strap - but if you want upper right, you could probably modify the design to add it. 

Attaching it

I used these screws: https://www.mcmaster.com/91792A533/
They are standard 1/4" 20 thread with a 1/4" shaft, and a 0.144" deep by 0.492" wide head. 

The grip presses tightly onto the body's built-in strap lug. To attach it, I press down into the table with the grip side down (see last image upload)

⚠ Disclaimer! Use at your own risk!

I have been using 3d printed tripod plate + strap connector combos for years with no problems, but ultimately the safety of your gear is up to you, and I take no responsibility for any damages caused if your copy of this design breaks or does not work with your gear.

Tags