Phone stand with hinges (print in place, no supports)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Project assumptions: 45 degree angle, printed in place, foldable, nice looking, no supports
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 109
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution
OK, there are a lot of "Phone stand" model. But this one is not the same. I made it to be:
Foldable for carrying
It gives a 45 degree phone angle
Possible to use phone in horizontal or vertical position
Nice looking
Printed in place as a complete model
No supports needed
Possible to modify a model as needed
Reinforced hinges with an internal structure
Optional built-in a kind of brim (just cut it off after printing)
Specific feature: possible to put face down and start recording with a finger through a hole for in-door climbing recording (45 degree angle is optimal in my case)
PLA recommended for good hinges performance (no hinges version does not matter).
Good luck :-)