Phone stand with hinges (print in place, no supports)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Project assumptions: 45 degree angle, printed in place, foldable, nice looking, no supports
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 23
- Makes
- 0
- Views
- 109
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Portable Devices
- License
- Creative Commons — Attribution
OK, there are a lot of "Phone stand" model. But this one is not the same. I made it to be:
Foldable for carrying
It gives a 45 degree phone angle
Possible to use phone in horizontal or vertical position
Nice looking
Printed in place as a complete model
No supports needed
Possible to modify a model as needed
Reinforced hinges with an internal structure
Optional built-in a kind of brim (just cut it off after printing)
Specific feature: possible to put face down and start recording with a finger through a hole for in-door climbing recording (45 degree angle is optimal in my case)
PLA recommended for good hinges performance (no hinges version does not matter).
Good luck :-)