towel rack bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
for mounting with tesa adhesive screws 2.5kg (77902-00002-00) there is 8cm between the wall to the center of the rod.…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 156
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution
for mounting with tesa adhesive screws 2.5kg (77902-00002-00)
there is 8cm between the wall to the center of the rod.
I have uploaded two variants, Ø15mm and Ø20mm to deliver a more flush look for the Räcka curtain rod that i intended to use for this project.
the print is assymetrical and will need a mirrored partner.
Print Settings
Printer Brand:
Creality
Printer:
Ender 5
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.2mm
Infill:
10%
Filament: devil design pla natural
Notes:
i printed with support in the indent for the anchor to ensure that the overhang would come out with minimal post processing.
Due to printing with support on the upper overhang i went through the cavity with a stubby knife to ensure good fitment between the anchor and the part.
How I Designed This
I wanted to print a strong bracket with more flair than just a wedge against the wall. To add strength in the direction of the adhesive anchor to the rod and back down to the bottom of the print i added in triangular support structures, this was also done to minimize the amount of material used on the print.
Category: Bathroom