1 / 2
Pimax Dream Air Ancillary Speaker Delete / Cable Fix v 2.0 / AVP + Vive DAS — zdjęcie 1
1 / 2

Pimax Dream Air Ancillary Speaker Delete / Cable Fix v 2.0 / AVP + Vive DAS

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Delete the speaker arms from your pimax dream air; Use an apple vision pro strap or vive das. Can revive dead cables.

Ocena
0 / 5
Polubienia
3
Pobrania
6
Wydruki
0
Wyświetlenia
874
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

(If you find any of my models for sale online (ebay, amazon, etc) it is not me, i do not sell prints; especially not at those insane prices. They are all listed as non-commercial works. I do not have a patreon or kofi or any donation platform. These models are only listed here on printables, for free, for you to print or use a print service like PCBway or JLCPCB, or your friends.)

  • A mod to remove the speakers from your pimax dream air cable

  • This mod can also revive dead cables.

  • It is not reversible

  • Understand there is a risk of damaging the cable, and you take responsibility for that

  • What you need:

    • M2 x 5mm long screws

    • Spudger

    • Wire Cutters

  • How to disassemble the speakers:

    • Insert the spudger near the cable exit and slowly work to the top edge.

    • Pull the plastic apart while spudging being careful to not hit the cable.

    • Spudge the bottom edge and work across the entire bottom.

    • Pull the casing apart.

    • Remove the 2x speed clips on the metal tension arms.

    • Unscrew the metal connector from the plastic housing and remove the tension arms. 

    • Snip the red and black speaker wires

    • Separate the metal connector from the housing

  • How to print:

    • Print 1x left + 1x right of the avp or vive version

    • Print 2x clamp rings

    • Split to parts, and print face down with build plate supports

    • Print with skirt for the clamp rings

  • How to assemble:

    • Wrap the bare wires in kapton or electrical tape.

    • Place the cable assembly into one half of the housing.

      • The small ridge on the metal connector faces down, the housing curves upwards.

      • Ensure a small gap exists between the connector and the casing edge.

        • This is the typically damaged area of the cable and we will potentially revive a dead cable here. 

        • Hold the cable in position while clamping the other half of the housing with the M2x5mm screws.

          • Start at the bottom end. 

          • Leave the top 2 screws at the other end loose. 

        • Slide the clamp ring on, force the connector downwards constantly, when the holes line up install the 2 m2x5mm screws highlighted in green. Afterwards tighten the red highlighted screws.

          • This process can save bad cables as it forces the conductors to bunch up and make contact again. 

  • Release: 4/5/26

  • Update: 8/13/26

    • Full redesign

    • Added vive DAS version

    • Added process instructions to help revive dead cables

Tagi