Pimax Dream Air Ancillary Speaker Delete / Cable Fix v 2.0 / AVP + Vive DAS
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Delete the speaker arms from your pimax dream air; Use an apple vision pro strap or vive das. Can revive dead cables.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 6
- Makes
- 0
- Views
- 874
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Virtual Reality
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
(If you find any of my models for sale online (ebay, amazon, etc) it is not me, i do not sell prints; especially not at those insane prices. They are all listed as non-commercial works. I do not have a patreon or kofi or any donation platform. These models are only listed here on printables, for free, for you to print or use a print service like PCBway or JLCPCB, or your friends.)
A mod to remove the speakers from your pimax dream air cable
This mod can also revive dead cables.
It is not reversible
Understand there is a risk of damaging the cable, and you take responsibility for that
What you need:
M2 x 5mm long screws
Spudger
Wire Cutters
How to disassemble the speakers:
Insert the spudger near the cable exit and slowly work to the top edge.
Pull the plastic apart while spudging being careful to not hit the cable.
Spudge the bottom edge and work across the entire bottom.
Pull the casing apart.
Remove the 2x speed clips on the metal tension arms.
Unscrew the metal connector from the plastic housing and remove the tension arms.
Snip the red and black speaker wires
Separate the metal connector from the housing

How to print:
Print 1x left + 1x right of the avp or vive version
Print 2x clamp rings
Split to parts, and print face down with build plate supports
Print with skirt for the clamp rings

How to assemble:
Wrap the bare wires in kapton or electrical tape.
Place the cable assembly into one half of the housing.
The small ridge on the metal connector faces down, the housing curves upwards.
Ensure a small gap exists between the connector and the casing edge.
This is the typically damaged area of the cable and we will potentially revive a dead cable here.

Hold the cable in position while clamping the other half of the housing with the M2x5mm screws.
Start at the bottom end.
Leave the top 2 screws at the other end loose.

Slide the clamp ring on, force the connector downwards constantly, when the holes line up install the 2 m2x5mm screws highlighted in green. Afterwards tighten the red highlighted screws.
This process can save bad cables as it forces the conductors to bunch up and make contact again.

Release: 4/5/26
Update: 8/13/26
Full redesign
Added vive DAS version
Added process instructions to help revive dead cables