K1 Series Buildplate Relocation - DB8 (2/3)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Parts and guide for heatbed relocation of K1 Series printers
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 129
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Public Domain
Due to Dragonburner modification I made stock heatbed is sitting too low (2-3mm) and toolhead is not reaching it - that is at least simple fix, just print and add spacer I made under springs before inserting them back.
However there is slightly bigger issue, also due to toolhead location now nozzle has been shifted roughly 30mm to the front door - to fix that you can either:
place buildplate 30mm to the front each time (which wont heat that 3cm of area properly)
Remove heatbed and supporting plate, use pressure sensors to draw cutting holes - Two bottom mounting holes align perfectly as future top mounting holes for each sensor.
For bottom sensors you could just screw 2 of the available mounting holes and keep it like that, or you can print provided support part and use it as additional structural support.
