K1 Series Buildplate Relocation - DB8 (2/3)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Parts and guide for heatbed relocation of K1 Series printers
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 5
- Makes
- 0
- Views
- 130
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Public Domain
Due to Dragonburner modification I made stock heatbed is sitting too low (2-3mm) and toolhead is not reaching it - that is at least simple fix, just print and add spacer I made under springs before inserting them back.
However there is slightly bigger issue, also due to toolhead location now nozzle has been shifted roughly 30mm to the front door - to fix that you can either:
place buildplate 30mm to the front each time (which wont heat that 3cm of area properly)
Remove heatbed and supporting plate, use pressure sensors to draw cutting holes - Two bottom mounting holes align perfectly as future top mounting holes for each sensor.
For bottom sensors you could just screw 2 of the available mounting holes and keep it like that, or you can print provided support part and use it as additional structural support.
