Remade X and Y axis for the Smartrapcore
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I really liked this X carriage (https://www.thingiverse.com/thing:1505842/files) because of the built in belt…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 140
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
I really liked this X carriage (https://www.thingiverse.com/thing:1505842/files) because of the built in belt tensioner, but the files were (and still are) bad and could not be sliced properly (not water tight) also did not included a e3d v6 mount.
One thing leads to another and I remade the X carriage and the Y slide parts, replacing the 608 bearing for 3d printed ones, but you will need a 6mm smooth rod where the 3d printed idlers will spin on, a screw will chew them in no time.
I used this fan duct https://www.thingiverse.com/thing:3160328
Print Settings
Resolution:
0.2
Infill:
25%
Filament: ebaycrap Use whatever works for you black
Category: 3D Printer Parts