Progress LED status bar for Infimech TX / Flyingbear S1
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
LED status bar for 3D printer, inspired by H2D. It displays the printer status, print progress, bed temperature...
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 280
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
Progress LED Status Bar for Infimech TX / Flyingbear S1
LED status bar for a Klipper-controlled 3D printer, inspired by H2D.
Displays real-time printer state, print progress, and bed temperature.
The project works out-of-the-box — no changes to printer configuration required.
All effects and LED control are handled by a low-cost ESP32 board, keeping the setup simple and affordable.
Firmware & Source Code and more information: https://github.com/nezg/klipper-led-state
Minimum required components:
ESP32, ESP32-C3, or ESP32-S3 board (i use esp32 c3 - https://ali.click/q0zu41d)
Any 5V addressable LED strip (WS2812/NeoPixel compatible) (200led/m led strip - https://ali.click/wsyu41x)
Power supply for board and LED strip (5V, current depends on strip length, e.g., DC-DC 24V → 5V) (dc dc 24 -> 5v https://ali.click/y4zu41s)
4× magnets 8×2 mm
Installation (specific to these printers)
Power is taken directly from the printer board — there is a 16-pin connector with always-on 24V.
1. DC-DC input:
24V → DC-DC input (from 16-pin motherboard connector)
2. After DC-DC (5V):
+5V → LED + ESP32 (5V pin)
GND → LED + ESP32
3. Data signal:
ESP32 GPIO4 → LED DATA
👉 If you like the project — leave a like and ⭐ on GitHub
👉 Forks for other Klipper printers are welcome
firmware questions → GitHub
model / mounting questions → here