Duender Dragon Burner v8 for Roller Wheel Modified Extruder Plate
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Duender Dragon Burner v8 for Roller Wheel Modified Extruder Plate
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 157
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- GNU General Public License v2.0
I had great success with the original gantry plate on my Ender 2 Pro, and when building the Duender I wanted to go with the Dragon Burner. The original model was modified to allow for the belts to wrap around the modified Extruder plate.
Install:
I found it easier start all the screws in first, then feed the belt through to give it a rough fit, then loosen the belt tensioners completely out, and add 2-3 teeth through the Extruder Plate. Lastly, connect the belt tensioners back.
Print settings:
I printed it first in Pink PLA so I could test fit. The final part was printed in Yellow ABS with Voron Specifications. Support was added, but if your printer is good enough for your material, this may not be required.
Hardware:
Same requirements as original model.
I used the following BLTouch mount. https://www.printables.com/model/890487-dragon-burner-v8-ender3-x-plate-mount
Additionally, I'll be posting a small remix to the mount as mine was a bit too low with my Dragon Burner combination.