Navigation holder for Yamaha Tenere 700 - Bepocam
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a holder for a Bepocam navi for the Yamaha Tenere 700
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 33
- Wydruki
- 0
- Wyświetlenia
- 313
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Share Alike
This is a holder for a Bepocam navi for the Yamaha Tenere 700.
The unit features GPS, optionally tyre pressure and temperature and optionally two cameras for front and back: https://de.aliexpress.com/i/1005010477994256.html
The photos show my test prints with PLA. I already printed in black ASA, but didn't mount that yet.
Print it with the maximum layer height your printer/nozzle supports and at least 6 Perimeters. If you are concerned about the surface finish, ASA can be vapor-smoothed with acetone and that also increases layer adhesion.
In extra hardware you will need:
5 * M heaset inserts
9 * M3 washer
optionally 9 * M3 locking washers between screwhead & washer
1 * self-locking M3 nut
4 * M3x12
4 * M3x16 (?)
1 * M3x25
optionally threadlocker
I put a 1.6 mm thick acrylic foam tape around the bar to dampen vibrations.