1 / 5
Brackets for Acrylic Box Enclosure — zdjęcie 1
1 / 5

Brackets for Acrylic Box Enclosure

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

These are brackets that I used to assemble an acrylic box enclosure for my printer. They are designed to work with…

Ocena
5 / 5
Polubienia
39
Pobrania
188
Wydruki
1
Wyświetlenia
1393
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution

These are brackets that I used to assemble an acrylic box enclosure for my printer. They are designed to work with 1/8"* acrylic, which can be purchased at any hardware store. If you use all of the screw holes (except the bottom 8!), you should use 72 M3x12mm screws, 72 lock nuts, and 144 washers. I don't know that the washers are strictly necessary, but they can be purchased on Ebay in hundred packs for a dollar or two.

  • 1/8" acrylic is actually ~0.10 inches in thickness.

Print Settings

Printer:

Maker's Tool Works MiniMax

Rafts:

No

Supports:

No

Resolution:

0.6mm, but you could use 0.4mm and some patience

Infill:

Shouldn't matter much


Notes:

Use the jig to drill the center holes by placing the jig over a piece of acrylic, drilling, then placing an M3 screw in each hole to keep it in place while you drill the adjacent acrylic panel.

How I Designed This ===================

Design process was very iterative, meaning I tried about a dozen very similar things and kept not liking them.

Category: 3D Printer Accessories

Tagi