Brackets for Acrylic Box Enclosure
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
These are brackets that I used to assemble an acrylic box enclosure for my printer. They are designed to work with…
- Rating
- 5 / 5
- Likes
- 39
- Downloads
- 188
- Makes
- 1
- Views
- 1,393
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
These are brackets that I used to assemble an acrylic box enclosure for my printer. They are designed to work with 1/8"* acrylic, which can be purchased at any hardware store. If you use all of the screw holes (except the bottom 8!), you should use 72 M3x12mm screws, 72 lock nuts, and 144 washers. I don't know that the washers are strictly necessary, but they can be purchased on Ebay in hundred packs for a dollar or two.
- 1/8" acrylic is actually ~0.10 inches in thickness.
Print Settings
Printer:
Maker's Tool Works MiniMax
Rafts:
No
Supports:
No
Resolution:
0.6mm, but you could use 0.4mm and some patience
Infill:
Shouldn't matter much
Notes:
Use the jig to drill the center holes by placing the jig over a piece of acrylic, drilling, then placing an M3 screw in each hole to keep it in place while you drill the adjacent acrylic panel.
Design process was very iterative, meaning I tried about a dozen very similar things and kept not liking them.
Category: 3D Printer Accessories