Janod Baby Walker Click Wheel Cap (J04410)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement cap for Janod walker click wheel. Restores clicking function. Prints without supports.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 32
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Description
This is a replacement click wheel cap for the Janod Baby Walker (J04410).
The original part contains a small internal pin that creates the clicking sound when the wheel/knob is turned. In my case, this pin had broken off, so I designed a replacement to restore the function.
The part is simple, durable, and designed to print cleanly without supports. Once installed, it brings back the original tactile and audible feedback.
Perfect for repairing second-hand or heavily used walkers.
Key Features
Designed for Janod Baby Walker (J04410)
Restores clicking sound function
Simple and durable design
No supports required
Fully 3D printable
Easy replacement part
Print Settings
Material: PLA or PETG
Layer height: 0.2 mm
Infill: 20–30%
Supports: Not required
Print orientation: As provided
Installation
Remove the broken cap
Press-fit the new part into place
Ensure the internal pin aligns correctly to generate the clicking action
Notes
Fit may vary slightly depending on printer tolerances
PETG recommended for higher durability
Designed based on a used/second-hand walker
Disclaimer
This is a DIY replacement part. Muffelkraft assumes no responsibility for improper installation or misuse.