TIC TAC GUN 2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
DIY Tic Tac Gun 2: spring-powered launcher with improved holder, optional rubber band boost, PLA print-ready design.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 60
- Wydruki
- 0
- Wyświetlenia
- 324
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
THE SUPER AWESOME Tic Tac Gun 2!
External Parts required-
x1 Pen spring
x1 Rubber band (Optional for stronger power)
x4 m3 nuts ( Screwfix code- 1184T)
x4 m3 bolt 20mm ( Screwfix code- 5875J)
x1 tic tacs ( Any flavour! )
How to build-
Install the pen spring on the little tab on the rear of the gun.
Place the 4mm spring barrel in the slot.
Line up the trigger with the middle hole and make sure the barrel & spring move freely.
Place the mag into the top slot.
Install the other side of the gun and screw it all together.
Open your tictacs, discard the lid, and place the carton on top of the gun. Fire away! ( If the tictacs don't come out now and again, give it a good shake!)
Add a small elastic band to the side of the gun for more power if necessary.
This design features a better tic tac carton holder on top of the gun, its designed to prevent the tictac container from falling off in the original design. Also, it has the additional rubber band side feature to add more fire power. Prints fine and strong enough in PLA with these pre-made infill/wall settings.
Not suitable for children due to small parts; always use under adult supervision.